Handmade pickup for bridge position, suitable
for direct replacement of Strat sized pickups, with no need for any adaptation.
It is particularly dedicated to those who love the typical tone of the P90 but
are not willing to adapt the body of their guitar and / or to accept the
aesthetic change.
TEXT CONTINUE AFTER PICTURES
The bobbin (which has physical characteristics
identical to those of the P90, except for his lateral extension) was wound by
guiding the wire by hand. Unlike the MINI P90 MkI and HALF DOLLAR models, the
MINI P90 MkIIIs are wound using AWG44 wire instead of AWG42.
This means that since the wire is thinner
(0.050 mm instead of 0.063 mm), a greater number of turns can be wound on the
same type of coil used for the MINI P90s. Consequently, thanks also to a
powerful neodymium magnetic system, the output level boasted by this pickup is
unknown to the vast majority of other existing single coils, including P90 in
standard format (especially if equipped with AlNiCo magnets). Output levels
aside, compared to the MINI P90 MkI voicing is characterized by a greater
emphasis on medium-low frequencies, due to the resonance peak of the coil
characterized, in fact, by a greater number of turns.
The Rs of this pickup is 12.6 Kohm (measured
at an ambient temperature of 26 ° C).
MINI P90 MkIII are also available for the
central position (Rs = 11.8 Kohm) and for the neck position (Rs = 11.4 Kohm)
and each pickup can also be requested in black or cream. The pickup for the
middle position is RWRP compared to the others.
The waxing was carried out in a mixture of
paraffin and beeswax (3: 1 w / w), to ensure immunity against any unwanted
squeal, maintained over time.
The connection cable is shielded.
The entire MINI P90 MkIII set can also be requested already installed on a pre-wired pickguard.
In sale on Reverb.com : https://reverb.com/item/35561352-mini-p90-mkiii-handmade-strat-sized-neodymium-pickup-for-bridge-position
Nessun commento:
Posta un commento